C-COM Satellite iNetVu 7710 User Manual page 28

C-COM Satellite Systems Inc.
5 – System Status (status meanings explained in the software section of this report)
AC Azimuth Calibration
AT ACP Testing
CC Compass Calibration
DT Dish Testing
II Idle
MM Manual Movement
PC Polarization Calibration
PK Peaking (PA/PE)
PS Positioning
SR Searching
ST Stowed
6 – Receive RF/DVB Signal
Receive RF Signal as measured from the LNB. The letter 'N' next to the RF Value indicates the
LNB is not being powered properly and there is an issue with the RF connection, whereas no
letter next to the RF value indicates the LNB is powered properly. When the system is not in RF
search Mode, and is searching via DVB carrier, the value represents the DVB signal, and the
letter "L" next to the value indicates a DVB signal LOCK.
7 – Modem Status
Displays the receive strength of the satellite, and the Modem/Transmitter Status.
D Transmitter Disabled
E Transmitter Enabled
U Unknown (Communication with Satellite Modem / VSAT has failed)
(E.g. M140D represents modem signal strength of 140, and transmitter is disabled)
8 – Beacon Receiver Signal
This section represents the strength of the Beacon Receiver Signal (if used). The letter 'U' next to
the Beacon Signal indicates an unlocked status, whereas the letter 'L' next to the Beacon Signal
indicates a Locked on satellite status
.
iNetVu™ 7710 Controller User Manual
28