C-COM Satellite iNetVu 7710 User Manual page 83

C-COM Satellite Systems Inc.
Restore Compass (Applicable on All)
Restores the compass to its factory calibrated state.
8.2.2.8 Maintenance Menu Buttons
The following buttons are available in the maintenance menu for multiple purposes including, ease of use,
troubleshooting, accessing of data files and more.
Test (DEMO)
Opens System Test and Demo menu screen
*SatParam File Gen
Generates Satellite Parameter table file "iNetVu7710_SAT_PM.S19" that will be
downloaded to the controller. This step is required after changes made to the
satellite parameters table.
*Upload SatParameter
Loads all the Satellite Transponder information located in the
"iNetVu7710_SAT_PM.S19" into the 7710 Controller. The user may modify the
table (iNetVu7710_PARSAT.txt with any DVB transponders settings) that he/she
would like saved in the 7710 Controller. The file would then be generated and
uploaded to the controller using this button. Controller must be in S file loading
mode.
*Load FW for 7710 (Main Controller Firmware)
Loads the iNetVu7710_Box_FW.S19 firmware file into iNetVu
the iNetVu program folder. The update process is displayed on screen and will
notify the user when the process is complete. 7710 Controller will reset itself
once the firmware updating is complete.
*Load FW for 7720 (Remote Drive Module Firmware)
Loads the iNetVu7720_RTCTL_FW.S firmware file into iNetVu
Reset
Restarts controller
Restore
Resets all platforms to the manufacture's default values, and resets beam(s), and
modem parameters settings to their defaults
Download Log File
Downloads the log data from the 7710 Controller onto the user's PC. The user may
select how much of the log file to upload from the Controller section of this
maintenance menu. The maximum data a user may upload is 12 hours.
Save All
Sends and saves ALL parameters to the controller's memory.
* Enabled ONLY when the 7710 controller is in Firmware loading mode.
.
iNetVu™ 7710 Controller User Manual
® Controller from
® Controller
.
83
.