C-COM Satellite iNetVu 7710 User Manual page 85

C-COM Satellite Systems Inc.
Test EL/AZ/PL
Moves and rotates to the values set in the Start Angle and End/Demo Angle fields.
Test Compass
Positions Antenna to the set Elevation angle and updates compass heading by
moving to the set End Angle values entered by the user on all three axis. Only end
angles are required when testing or validating compass.
Stop Test
Halts all test/demo sequences.
Test Elevation
Moves dish to the values set in the Start Angle and End/Demo Angle fields
Test Azimuth
Moves dish to the values set in the Start Angle and End/Demo Angle fields
Test Polarization
Rotates dish to the values set in the Start Angle and End/Demo Angle fields
Modem Test (Command)
(This Feature has not been fully tested with the iDirect Modem at this time of
documentation)
The user may enter certain modem commands, and click send. The 7710 Controller will then
read the response from the modem in the text area below the command line. Currently the
commands supported are for iDirect services only:
 laninfo
 tx power
 tx freq
 tx symrate
 tx cw
 rx power
 rx freq
 rx symrate
 latlon
iNetVu™ 7710 Controller User Manual
85