C-COM Satellite iNetVu 7710 User Manual page 51

C-COM Satellite Systems Inc.
c) NMEA
This option allows the user to communicate and output GPS readings/values from the
7710 Controller via COM Port (RS232) connection. The default baud rate is 9600.
d) DBUG-19200 (internal use only)
2 – Unattended Operation
This option is used for remote operations where system is left unattended as the name indicates,
mainly for unmanned sites. This feature must not be used when the iNetVu system is being moved
around or in transport mode. In this case, the system should be powered off completely. Otherwise, there
is a risk of the antenna attempting to deploy while vehicle is moving. Please ensure this feature is turned
off when vehicle is in transit from one location to another.
The user may disable, or set the unattended re-deploy delay time to 5, 10, or 15 minutes. If the
system detects motion it will wait 1min, if dish still on signal the system will re-acquire satellite, otherwise
the dish will stow due to motion or movement, the system will automatically re-acquire satellite depending
on the user entered delay time after stow. Initial stow will only wait 30 seconds no matter what the
selected delay time is set to before re-acquiring satellite.
For example, if the user selects 5 minutes from the drop down menu, and the system stows due to motion
or movement while operational, on first stow it will only wait 30 seconds before re-acquiring satellite.
The second stow, system waits Five (5) minutes + 30 seconds before automatically re-acquire
the satellite signal. The routine uses the following formula: Waiting Time for re-acquire == 30S+ (retry
times*selected delay time) default retry time at first stow is 0, second stow is 1, etc... until one (1) hour
(3600 seconds) reached. If after (1) hour system does not find satellite it will continue to try on every hour
thereafter. The retry time will be reset 0 after each time the system locks on satellite.
DIS: Disabled
1: Re-acquire Satellite in 5 minutes
2: Re- acquire Satellite in 10 minutes
3: Re- acquire Satellite in 15 minutes
DANGER: The system may try to deploy if this option is selected and vehicle becomes in
motion. Unattended option must be disabled when vehicle is moving and system is NOT
powered off.
3 –DHCP Status
The 7710 Controller can be programmed to obtain an IP address from a DHCP Server (i.e.
modem, router, etc.)
D – DHCP Disabled (IP must be entered statically)
E – DHCP Enabled (Controller will dynamically obtain an IP address from the DHCP Server)
4- Beep
This option allows for enabling and disabling the Beeping sound when navigating the LCD screen
through the front panel keypad.
D – Beep Disabled, the sound will be completely removed.
E – Beep Enabled, a beeping sound will occur every.
iNetVu™ 7710 Controller User Manual
51