C-COM Satellite iNetVu 7710 User Manual page 65

C-COM Satellite Systems Inc.
The Isolation Value will correspond to the transmit quality of an HNS system. Otherwise, this field
is not applicable.
Date/Time
Current date and time as received from the GPS/Glonass Antenna. Should the GPS/Glonass
experience any problems, the alternate source is your PC internal date and time.
Automatic Control
Select Satellite
Select Satellite
Satellites that user can select from by simply clicking on the drop down arrow. Satellites
1 to 64 can be preconfigured and saved to allow user to search for desired satellite.
Beam color will be displayed and will not be selectable if "Auto-select Beam color" is
enabled for Tooway. Currently Only 16 can be set with the remaining to be added in
future versions. Sat 1 is default satellite and will be the one searched on if no other is
selected from the drop down list.
Find Satellite
Automatically finds and locks onto the satellite signal by communicating with the Satellite
Modem and using the GPS coordinates, the compass heading, and internal parameters
of the Satellite Modem. Typically, it takes approximately 3-5 minutes to find satellite.
If the Antenna is already pointed on the satellite, clicking Find Satellite will re-peak the
Antenna onto the signal. Search routine will ignore GPS and RF status until after
compass heading has been read to reduce search time. If GPS and RF conditions not
met after 60 seconds the search will fail and a message will be displayed.
Fig. 57: Isolation Value Display
Fig. 58: Date/Time Display
Find Satellite
Fig. 59: Automatic Control Buttons
iNetVu™ 7710 Controller User Manual
Stow Antenna Stop Operation
65