C-COM Satellite iNetVu 7710 User Manual page 78

C-COM Satellite Systems Inc.
78
Polarization Offset (PL)
By default this polarization-offset value is set to 0°. If there happens to be a requirement for a polarization
offset, the user may manually enter this value in this area. This area is also updated automatically if the
skew adjustment procedure recognizes an incline which will adjust the target polarization angle.
8.2.2.3 PC Application
This sub-section contains options regarding the relevant IP address connection to the iNetVu ®
Series 7700 Central Controller. This section allows user to enter IP address of the desired
controller that they wish to connect to over the network.
ACU (Antenna Control Unit) IP Address
User can enter IP address of a networked controller and connect to it over the Network.
Com Port
Used in conjunction with the serial port interface (Interface parameter under COM Port Configuration
section) communication between the controller and pc.
Log Data
The user may choose to upload either 1 hour, 2 hours, or ALL (maximum of 12 hours) of the recorded
data log information from the controller to the PC. The log file is saved in the default installation location
as "iNetVu7710Data_history"
8.2.2.4 Satellite
The Target satellite drop down allows the user to select from list of saved satellites, longitudinal and
orbital values the target satellite to search on, the list will currently save and display 16 target satellites
(eventual will allow for 64 target satellites to be saved). There is a new feature that has been added,
Multiple Satellite Search. The Satellite search when enabled will allow the search routine to continue
searching on the next target satellite in the list, currently the operator can configure and or set 3 satellites
that the search routine will automatically toggle through in the order they are listed while attempting to
lock on satellite signal if the first in the list fails.
iNetVu™ 7710 Controller User Manual