C-COM Satellite iNetVu 7710 User Manual page 98

C-COM Satellite Systems Inc.
98
Beacon Freq (MHz)
This field represents the frequency that the Optional Beacon Receiver is programmed for. The user may
change this frequency to whatever Beacon is required for the target satellite. 64 configurable Beacon
frequency maybe configured with 64 Beam ID, thus providing the user 64 target satellites to choose from.
If the iNetVu ® Beacon Receiver is not used, this field can be ignored.
ACQ Attenuation (dB)
The 7710 controller software interfaces give the user flexibility to set the power level of the signal when
.
searching using the beacon receiver. This field is only related to the optional iNetVu Beacon Receiver
8.2.4.7 Controller Parameters
This sub-section contains data concerning the relevant IP addresses of the iNetVu ® 7710 Controller.
Fig. 78: Configuration – Controller Parameters
IP Address
The IP address assigned to the iNetVu ® 7710 Controller.
Subnet Mask
The Subnet Mask IP Address used by the iNetVu ® 7710 Controller for PC and modem connectivity.
Default Gateway
The Gateway IP address used by the iNetVu ® 7710 Controller.
DHCP
The iNetVu 7710 Controller could obtain a dynamic IP address from a DHCP Server (i.e. router, modem,
®
etc.) if this option is enabled.
iNetVu™ 7710 Controller User Manual