C-COM Satellite iNetVu 7710 User Manual page 91

C-COM Satellite Systems Inc.
Modem Delay
The user may increase the delay time when polling for modem signal by adjusting this number.
Increasing this number, will increase the time to find and lock on to satellite as it slows down controller
activity and allows slower modems to catch up.
IP Address
This area is reserved for the modem IP address.
Automatic TX Disable (Available with All Modem Services)
This option feature will appear under all existing modem services, if this option is selected (by default its
checked), the controller will automatically disable the transmitter (TX) after the communication between
the modem and controller is re-established due to controller or modem communication failure during
transmission as a result of one or both devices rebooting, power outage or any other cause of
communication drop. TX will be disabled only after communication is re-established. To Leave the TX
enabled after communication is re-established uncheck this option.
Tooway Modem Options:
Auto-select Beam Color
This option is only available with the Tooway modem service. Select the Auto-select Beam Color to have
the system automatically lock on the Beam Color by referring to the built in lookup tables and GPS
location.
Update look-up Table
The Tooway Look-up Table must be uploaded to the Controller via the Application software this allows
the beam table to be saved and used within the controller; this must be performed before it can be used
directly from the Controller LCD. This process is only required once as long as no changes are made to
the Beam Colors which than will require another Table Upload.
To enable this feature from the 7710 front panel do the following:
a. Put 7710 Controller into S File Downloading mode ( same mode as updating Firmware)
b. Click on Update look-up Table button
c. Monitor status on bottom left hand
iNetVu™ 7710 Controller User Manual
91