Table of Contents
Advertisement
All assemblies are indexed by tab except for the ones listed in Table 1 at the end of this
section. Table 1 lists the index tabs where these assemblies can be found.
Assembly 1
A2
Storage and Shipment
Environment
The instrument may be stored or shipped in environments within the following limits:
Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Humidity
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..5%t to 90% at 0"to 40°C
Altitude . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Up to 15,240 meters (50,000 feet)
The instrument should be protected from temperature extremes which might cause
condensation within the instrument.
Original Packaging
It is recommended that the original factory packaging materials be retained for use when
shipping the instrument. If original packaging material cannot be retained, packaging
materials identical to those used in factory packaging are available through Hewlett-Packard
offices. Part numbers and descriptions of the packaging materials are listed in Figure 1.
The combined weight of the two instrument sections is approximately 50 kg (112 lbs).
Because of the weight involved, do not package the instrument sections fastened together as
one unit. The instrument sections must be separated and packaged in separate containers.
The quantity of packaging materials in Figure 1 is for only one instrument section.
If the instrument is being returned to Hewlett-Packard for servicing, attach a tag to each
carton indicating the type of service required, return address, model number, and full serial
number. For your convenience, a supply of tags is included at the end of this section. Also,
mark each container FRAGILE to assure careful handling. In any correspondence, refer to the
instrument by model number and full serial number.
Other Packaging
If it is necessary to use packaging materials other than the type used in original factory
packaging, the following general instructions should be followed.
Assembly Locations
Tab Location
General Parts Listing, Table 6
General Parts Listing, Table 6
General Parts Listing, Table 4
Not Assigned
IF-Display Section General Information 3
I
Advertisement
Table of Contents
