Select Vertical Printing (For Hanzi Big5 Printer Only); Select Vertical Tab Channel; Set 0-Dot Intercharacter Spacing Of Dbcs Characters - InfoPrint LQ-1600K Programmer's Reference Manual

Select Vertical Printing (for Hanzi BIG5 Printer only)

Select Vertical Printing (for Hanzi BIG5 Printer only)
ASCII Code SSCC + n
SSCC 2B n
Hex Code
Dec Code SSCC 43 n
Purpose The character is printed with different degrees of rotation in the
counter-clockwise direction under DBCS mode.
n = 0 or 48
n = 1 or 49
n = 2 or 50
n = 3 or 51
n = 4 or 52
Where:
n = 0, 1, 2, 3, 4, 48, 49, 50, 51, 52
The default value is n = 4, normal character.
Comment
NOTE: This command is only supported in the Hanzi TW printer.

Select Vertical Tab Channel

ASCII Code ESC / c
Hex Code 1B 2F c
Dec Code 27 47 c
Purpose Selects a vertical tab channel set by ESC b.
Where:
c = 0 through 7
Comment Subsequent VT (hex 0B) commands use tab table specified by
c. If no tab table is selected, table 0 is used.

Set 0-dot Intercharacter Spacing of DBCS Characters

ASCII Code SUB Q
Hex Code 1A 51
Dec Code 26 81
Purpose Sets 0-dot intercharacter spacing of DBCS characters.
Comment This command affects the front panel setting of "DBCS CPI."
90 degrees rotation
180 degree rotation
270 degree rotation
rotate DBCS full width character 90 degrees
normal character
69