Table of Contents
Advertisement
Chapter
2
Configuring The LQ-1600K Emulation With Control Codes
Set Form Length In Inches
ASCII Code ESC C NUL n
Hex Code
Dec Code
Purpose
Comment
Set Font Pitch (For Hanzi Big5 Printer Only)
ASCII Code ASSC 0
Hex Code
Dec Code
Purpose
Comment
74
1B 43 00 n
27 67 0 n
Sets form length to n inches .
Where:
n = 1 through 22 to specify the number of inches on a form.
Upon receipt of this code, the current line becomes the first line
of the form, and the form length set becomes the current forms
length. Vertical tab positions set below the bottom of the form
are ignored. Forms length is defined in inches; therefore,
subsequent line spacing changes do not affect the result of this
command.
Values of n greater than 22 are ignored.
When forms length is set by an ESC C sequence, the skip-over
perforation set by ESC N is cancelled.
This control code overrides forms length set at the control
panel.
T
P
n1 n2 n3 n4
ASSC 30 54 50
n1 n2 n3 n4
ASSC 48 84 80
n1 n2 n3 n4
To set character spacing by dot in 300 dpi, which will convert to
180 dpi. The character spacing includes character width and
inter-character spacing. The character width refers to DBCS
single byte character width in normal mode.
Where
n1, n2, n3, n4 = 0x30 ~ 0x39
This control codes does not function while in non-DBCS mode.
Advertisement
Table of Contents
