Set Intercharacter (Two-Byte) Spacing In Dbcs Mode; Set International Character Set - InfoPrint LQ-1600K Programmer's Reference Manual

Chapter 2
Configuring The LQ-1600K Emulation With Control Codes

Set Intercharacter (Two-Byte) Spacing In DBCS Mode

ASCII Code FS S n1 n2
Hex Code
Dec Code
Purpose
Comment

Set International Character Set

ASCII Code ESC R n
Hex Code
Dec Code
Purpose
76
1C 53 n1 n2
28 83 n1 n2
Defines preceding/succeeding dots for intercharacter spacing.
This control code defines the space to the left/right of the
printed character in dot positions. The dot size for n1 and n2 is
equal to 180 dpi. The default for n1=0 and n2=3. This control
code does not function while in non-DBCS mode and only for
two-byte characters in DBCS mode.
1B 52 n
27 82 n
Specifies a language overlay that prints the characters shown
in Table 9 when the specified code is invoked.
Where:
n = hex 0 through E to determine the language overlay shown
in Table 9.
The real Epson only defines character sets through hex C.