Table of Contents
Advertisement
Chapter
2
Configuring The LQ-1600K Emulation With Control Codes
Set Margin (Right)
ASCII Code ESC Q n
Hex Code
Dec Code
Purpose
Comment
Set Paper Length (For Hanzi Big5 Printer Only)
ASCII Code ASSC 0
Hex Code
Dec Code
Purpose
Comment
80
1B 51 n
27 81 n
Where:
n = 1 through 255; number of columns from the left edge of the
physical page to the end of the print line.
Sets the right margin to n columns at the current character
width.
The number of inches of margin does not vary if the font,
character width, or horizontal dot density changes. This
command automatically clears and resets horizontal tabs to
every eight characters, then performs a CAN operation. The
smallest possible space between the left and right margins is
the width of one double-wide 10 cpi character. If a margin
control code violates this minimum distance, it is ignored.
Settings in proportional mode are treated as 10 CPI.
In DBCS mode, the right margin will be set according to the
width of DBCS characters.
This command affects the front panel setting of "Right Margin."
T
C
n1 n2 n3
ASSC 30 54 43
n1 n2 n3
ASSC 48 84 67
n1 n2 n3
To set form length to 1/6 inches.
Where
n1, n2, n3 = 0x30 ~ 0x39
This control code does not function while in non DBCS mode.
Advertisement
Table of Contents
