Table of Contents
Advertisement
Chapter
2
Configuring The LQ-1600K Emulation With Control Codes
Select Super/Subscript Printing
(For Hanzi BIG5 Printer only)
ASCII Code SSCC
Hex Code
Dec Code
Purpose
Comment
Select Typeface (For Hanzi BIG5 Printer only)
ASCII Code ESC k n
Hex Code
Dec Code
Purpose
Comment
Select Underline Printing (For Hanzi Big5 Printer Only)
ASCII Code ASSC 0
Hex Code
Dec Code
Purpose
Comment
68
~
n
SSCC 7E n
SSCC 126 n
Prints characters that follow at about 1/2 their normal width and
1/2 their normal height; the printing location depends on the
value of n as follows:
n = 0 or 48
Upper part of the character space
n = 1 or 49
Lower part of the character space
n = 2 or 50
Normal character
Where:
n = 0, 1, 2, 48, 49, 50
Setting n =2 returns the character back to its normal height.
1B 6B n
27 107 n
This is to select DBCS ASCII typeface:
n = 0
Normal
n = 5
OCRB
Where:
n = 0, 5
This command only takes effect in DCBS mode.
T
-
n
ASSC 30 54 2D
n
ASSC 48 84 45
n
To set underline printing.
Where:
n = 0x30: reset (default)
n = 0x31: underline for all characters
n = 0x32: underline for all characters except space (0x20).
This control code does not function while in non-DBCS mode.
Advertisement
Table of Contents
