Delete Character; Double High Print, Set/Reset; Double Strike (Select) - InfoPrint LQ-1600K Programmer's Reference Manual

Delete Character

ASCII Code DEL
Hex Code 7F
Dec Code 127
Purpose Deletes the previous character on a line.
Comment This command is ignored if it occurs immediately after a CR or
a paper motion command. Characters truncated due to line
length restrictions are not affected by this code.

Double High Print, Set/Reset

ASCII Code ESC w n
Hex Code 1B 77 n
27 119 n
Dec Code
Purpose Turns double high character printing on and off. Double high
characters are standard width but twice as high.
Where:
n = SOH (hex 01) or 1 (hex 31) turns double high printing on
n = NUL (hex 00) or 0 (hex 30) turns double high printing off
Comment This control code does not function while in DBCS mode.

Double Strike (Select)

ASCII Code ESC G
Hex Code 1B 47
Dec Code 27 71
Purpose Makes text bolder by printing each dot twice.
Comment This command makes text bolder by printing each dot twice,
the second dot offset to the right of the first by a distance equal
to 1/2 the width of a dot, the same as with ESC E.
Delete Character
35