Send Error Code; Scan To Smb Error Codes - Kyocera TASKalfa 420i Service Manual

2KR/2KS
1-4-6

Send error code

(1) Scan to SMB error codes

Code Display
1102 Error: User/Password or
Shared Name/Folder Name
1103 Error: Pathname or File
Name
1105 Error: Not support protocol
2101 Error: Can not connect
2103 Error: Response wait with
timeout
2201 Error: Network transfer
2203 Error: Response wait with
timeout
9181 Error: Page max count over
1-4-62
Causes
Domain name is not entered.
Assign disable user/pass-
word.
Assign the user who is not
allowed to access to folder.
Assign disable shared name.
Host name error.
Domain name is not enter
Connect to the folder which is
not permitted for reference/
writing.
Assign disable folder path.
SMB Protocol is set to OFF.
Enter the disable host name/
IP address.
Assign the wrong port num-
ber.
Network is not connected.
The server is unable to com-
municate.
Error occurs on the network.
Response is not returned
from the server above speci-
fied time.
The number of pages of a
send file exceeded 999
pages.
Remarks
Check procedures/corrective measures
Enter the user name with the form of either
[Domain¥User], [Domain/User] or
[Domain@User].
Enter the correct user name/password.
Enter correct user name/password.
Check the access limit of destination folder.
Enter the correct shared name.
Check if the prohibited letters below are
used to shared name.
@( )!&#$%^~[ ]`
Check if the prohibited letters are used to
shared name.
"&'( )|`;<>
Enter the user name with the form of either
[Domain¥User], [Domain/User] or
[Domain@User].
Enter correct user name/password.
Check the access limit of destination folder.
Enter correct folder path.
Check ON in the [Scanner]-[SMB] screen in
COMMAND CENTER.
Enter the correct host name or IP address.
Enter the correct port number.
Check if the server is operating properly.
Check the network connection (cable. net-
work condition within LAN, etc.).
Check if the server is operating properly.
Check the network connection (cable. net-
work condition within LAN, etc.).
Check the network connection (cable. net-
work condition within LAN, etc.).
Set the number of pages as 999 or less.