Send Error Code; Scan To Smb Error Codes - Kyocera FS-C2026MFP Service Manual

1-4-6 Send error code

(1) Scan to SMB error codes

Code Display
1101
Host name error
1102 User/Password or
Folder/Shared name
error
1103 Folder path or File
name error
1105 Protocol error
2101 Server connect error
2201 Network transfer error Error occurs on the net-
2203 Response wait with
timeout error
9181 Page max count over
error
Causes
Enter the disable host
name of SMB server.
Domain name is not
entered.
Assign disable user/pass-
word.
Assign disable folder/
shared name.
Assign the user who is not
allowed to access to folder.
Host name error.
Domain name is not enter
Assign disable folder path.
Assign the user who is not
allowed to access to folder.
SMB protocol is set to
OFF.
Enter the disable host
name/IP address.
Assign the wrong port
number.
Network is not connected.
work.
Response is not returned
from the server above
specified time.
The number of pages of a
send file exceeded 999
pages.
1-4-42
Check procedures/corrective measures
Enter the correct host name in COMMAND
CENTER.
Enter the user name with the form of either
[Domain¥User], [Domain/User] or
[Domain@User].
Enter the correct user name/password.
Enter the correct folder/shared name.
Check the access limit of destination folder.
Check if the prohibited letters are used to
shared name.
` ~ ! @ # $ ^ & * ( ) = + [ ] { } \ | ; : ' " < > / ?
Enter the user name with the form of either
[Domain¥User], [Domain/User] or
[Domain@User].
Enter correct folder path.
Check the access limit of destination folder.
Enable SMB protocol in COMMAND CEN-
TER.
Enter the correct host name or IP address.
Enter the correct port number.
Check if the server is operating properly.
Check the network connection (cable. net-
work condition within LAN, etc.).
Check the network connection (cable. net-
work condition within LAN, etc.).
Check the network connection (cable. net-
work condition within LAN, etc.).
Set the number of pages as 999 or less.
2KW/2KX