Appendix 2 When Using Gx Developer; Appendix 2.1 Operation Of Gx Developer - Mitsubishi Electric MELSEC-Q series User Manual

Appendix 2
This chapter describes the operating procedure of GX Developer.
When GX Developer is used, perform the initial setting and auto refresh in the sequence program.
• Program example when not using parameters of the intelligent function module (
9.2.2 and Page 175, Section 9.3.2)
(1) Applicable software packages
For the applicable software version, refer to the following.
Page 20, Section 2.1 (4)
Appendix 2.1
Configure the following settings when using GX Developer.
Window name
I/O assignment
Switch setting
Offset/gain setting
(1) I/O assignment
Configure the setting on "I/O assignment" in "PLC parameter".
Parameter
Item
Type
Model name
Points
StartXY
244
When Using GX Developer
Operation of GX Developer
Set the type of the module to be mounted and the I/O signal range.
Configure the switch setting of an intelligent function module.
Configure the setting when using a user range setting for the input
range.
[PLC parameter]
Select "Intelli.".
Enter the model name of the module.
Select "16points".
Enter a desired start I/O number of the CT input module.
Application
[I/O assignment]
Description
Page 162, Section
Reference
Page 244, Appendix 2.1 (1)
Page 245, Appendix 2.1 (2)
Page 151, Section 8.5.2