(8) Channel change completed flag (XB)
When changing a channel to perform the offset/gain setting, use Channel change completed flag (XB) as an
interlock condition to turn on then off Channel change request (YB).
For the offset/gain setting, refer to the following.
• Offset/gain Setting (
Offset/gain setting mode Offset
specification (Un\G22),
Offset/gain setting mode Gain
specification (Un\G23)
Channel change completed
flag (XB)
Channel change request (YB)
84
Page 148, Section 8.5)
Controlled by the CT input module
Controlled by the sequence program
Channel where offset or gain is specified
OFF
OFF
ON
OFF
ON
OFF