Mitsubishi Electric MELSEC-Q series User Manual page 108

(3) Conversion completed flag (Un\G10)
The conversion status can be checked with this flag for each channel.
(a) Conversion completion
When the first digital conversion is completed for the channel for which Enable is set, Conversion completed
(1) is stored.
Conversion completed flag (XE) turns on when the digital conversion of all the channels for which Enable is set
is completed.
When Operating condition setting request (Y9) is turned on then off, Converting or unused (0), which is the
default setting, is stored. When the first digital conversion is completed, Conversion completed (1) is stored
again.
When CH1 and CH2 are set to Enable and the conversion of CH1 and CH2 is completed, 0003
Ex.
stored in Conversion completed flag (Un\G10), as shown below.
(4) CH Digital output value (Un\G11 to Un\G18)
The digital output value after digital conversion is stored in each channel.
(a) Updating cycle
When the average processing is performed, the value is updated in each specified averaging process cycle.
When the average processing is not performed, the value is updated in each sampling cycle.
(5) Latest error code (Un\G19)
The latest error code or alarm code detected by the CT input module is stored.
For details on the error code and alarm code, refer to the following.
• Error Code List (
• Alarm Code List (
(a) Clearing an error
Turn on then off Error clear request (YF).
106
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5
0 0 0 0 0 0 0
b8 to b15 are fixed to "0".
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5
0 0 0 0 0 0 0
0 0
Page 221, Section 11.1)
Page 228, Section 11.2)
b4 b3 b2
0 CH8 CH7 CH6 CH5 CH4 CH3
0: Converting or unused
1: Conversion completed
b4 b3 b2
0 0 0 0 0 0 0
CH8 CH7 CH6 CH5 CH4 CH3
0
b1 b0
CH2 CH1
b1 b0
1 1
CH2 CH1
3
(3) is
H