Chapter 9 Programming; Programming Procedure - Mitsubishi Electric MELSEC-Q series User Manual

CHAPTER 9
This chapter describes the programming procedure and basic programs for the CT input module.
9.1

Programming Procedure

Create a program to execute digital conversion, according to the following procedure.
Start
Use the configuration
function?
YES
Switch setting, parameter setting,
Page 156, Section 9.2, Page 165, Section 9.3
and auto refresh setting
Error reset program
End
PROGRAMMING
NO
Page 156, Section 9.2, Page 165, Section 9.3
Input range setting program
Conversion enable/disable setting program
Averaging process setting program
Primary delay filter setting program
Sampling cycle setting program
Scaling function setting program
Peak current detection function setting
program
Dropout function setting program
Logging function program
Input signal error detection function program
Warning output function program
Program to read a digital output value,
scaling value, warning output flag, input signal error
detection flag, and peak current detection flag
(2) Auxiliary program
*2 A program that is added according to the
control target (Create a program if needed.)

CHAPTER 9 PROGRAMMING

Switch setting
(1) Initial setting program
Set by using a program.
Page 156, Section 9.2, Page 165, Section 9.3
Initial setting
*1
*1
*1
*1
*1
*1 A program that is created according to
the function to be used
*2
*1
155
9