Mitsubishi Electric MELSEC-Q series User Manual page 244

Device
CH8 User range setting offset value
+34
S
CH8 User range setting gain value
+35
S
(3) Functions
• This instruction restores the offset/gain set values in a user range setting to the CT input module.
• There are two interlock signals of G(P).OGSTOR: a completion device
device
D
• The accuracy on restoration of the offset/gain setting values (when the ambient temperature is 25±5°C) is
within ±1.5% (within ±150 digit).
(a) Completion device
The device turns on at the END processing for the scan where the G(P).OGSTOR instruction is completed, and
turns off at the next END processing.
(b) Completion status indication device
This device turns on or off depending on the status of the G(P).OGSTOR instruction completion.
• Normal completion: the device remains off.
• Error completion: the device turns on at the END processing for the scan where the G(P).OGSTOR
instruction is completed, and turns off at the next END processing.
Sequence program
G(P).OGSTOR
instruction
Completion device D
Completion status
indication device D +1
(4) Errors
In the following cases, an error occurs and error code is stored in completion status
Error code
161
162
163
242
Item
+1.
END END
processing processing
ON
OFF OFF
OFF
OFF
G(P).OGSTOR instruction is executed in the offset/gain setting mode.
G(P).OGSTOR instruction is continuously executed.
• G(P).OGSTOR instruction is executed to the different model from the one to which G(P).OGLOAD
instruction is executed.
• G(P).OGSTOR instruction has been executed before the execution of G(P).OGLOAD instruction.
Setting data


Execution completion of
the G(P).OGSTOR instruction
Description of operation error
Setting range Set by

System

System
and a completion status indication
D
END END
processing processing
ON
OFF
ON: Execution failed
OFF: Execution succeeded
1 scan
+1.
S