Maintenance; General Instructions; Service Schedules - PRO ACTIV TRAVELER 4all Ergo Operating Instructions Service Booklet

If you need care products for your product,
please contact PRO ACTIV. You can also re-
quest our care set via the enclosed order card
or by telephone.

33 Maintenance

33.1 General instructions

The product is not a maintenance-free device.
Therefore, please observe the following in-
structions about maintenance.
If repairs are required or there are any
defects in your product, in the interests of your
own safety, you should contact your specialist
retailer or PRO ACTIV before using it again
and have the defect remedied. Screws and
other elements need to be secured properly
again after repairs.
For tyres with tread: As soon as there is
one or more points with less than 1 mm of
tread on the tyres, the tyres must be changed
as otherwise there is an increased risk of an
accident.
For tyres without thread: As soon as there
is one or more points where the tyre carcass or
the puncture-proofing is visible, the tyres must
be changed as otherwise there is an increased
risk of an accident.
Only manufacturer's original parts may be
used when ordering spare parts.
Repairs and conversions to the product
may only be carried out by your dealer or PRO
ACTIV.
Tightening torques and securing details for
fastening elements as shown in the table in
chapter 38 must be observed.

33.2 Service schedules

There is some maintenance work or checks
which should be carried out by the user
themselves at regular intervals (approximately
every 4 weeks depending on the frequency of
use):
55
Operating instructions TRAVELER 4all Ergo & 4you Ergo








ing these checks, please immediately contact
your dealer or PRO ACTIV. Service and repair
work on the product may only be carried out by
your dealer or PRO ACTIV.
In addition to these maintenance tasks /
checks by the user, PRO ACTIV has pre-
scribed maintenance tasks to be carried out
by the dealer or PRO ACTIV for safe opera-
tion of the product and to minimise the risk to
the user or third-parties.
The initial inspection is performed six weeks
after delivery. The maintenance schedule can
be found in the inspection lists in chapter 41.
Subsequent inspections are then always per-
formed after another year after the last inspec-
tion. The maintenance schedule can be found
in the inspection lists in chapter 41.
After extreme stresses, such as during holi-
days where the product was exposed to sand,
sea water or snow, an additional deep clean
and inspection by your specialist retailer is
recommended.
Check the tyres for damage, foreign bodies
and any cracks that form.
Check the tyre pressure and correct if
needed (the tyre pressure should always
be as printed on the tyre covers).
Check the brakes (function, wear on pivot
bolts).
Clean and oil the pivot points of the brakes
and check the ease of movement or actua-
tion force of the brake lever.
Check the function of the anti-tipping de-
vice.
Check the stable stand of the seat and
back padding.
Check the tight fit of the fixing screws on
the seat and back system.
Check the function and ease of running of
the quick-release axles of the drive wheels
and caster forks.
If you should discover any problems dur-