Table of Contents
Advertisement
As a last option for adjusting the effort required
when removing and installing the clothing
guard, slightly unscrew the M5 fixing screws
(AF 4 mm) and pull the "bolted side section
mount" along their slots a little further away
from the basic body of the side section mount
or press them a little closer towards the basic
body of the side section mount.
M5 fixing screws in the
"bolted side section mount"
Figure 66: Side section mount bolted to the basic
body of the side section mount with slots and M5
fixing screws (bottom view).
21.5 Clothing guard size
The clothing guard is available in three differ-
ent sizes. The dimensions of the wheel arches
differentiate with the different sizes:
Aluminium: 30 mm (Size 1), 36 mm (Size
2), 46 mm (Size 3)
Carbon: 30 mm (Size 1), 36 mm (Size 2),
42 mm (Size 3)
Dimensions of the wheel arches
Figure 67: Dimensions of the wheel arches
27
Operating instructions TRAVELER 4all Ergo & 4you Ergo
The size of the clothing guard can be read-off
the notches on the bottom edge of the clothing
guard. One notch means size 1, two notches
mean size 2 and three notches mean size 3.
Figure 68: Size marking on the clothing guard
After changing to a wider tyre size or after
changing the wheel camber, it may be neces-
sary to change to another clothing guard size.
Where required, such a change may be ar-
ranged by your dealer.
22 Drive wheels
vents hands and fingers entering and being
trapped in the wheels when riding. The risk of
injury is thus minimised.
Figure 69: Spoke guard for minimising the risk of
hands and fingers getting trapped
Size marking for size 2
Recommendation: The spoke guard pre-
Advertisement
Table of Contents
