Table of Contents
Advertisement
Figure 46: Ergonomic back shell (view from behind)
Then mount the back upholstery using the
Velcro straps.
Velcro cross-straps
Figure 47: Ergonomic back shell without back pad-
ding with Velcro cross-straps
To fold the product, the back shell must be
removed. To remove the back shell, pull the
release lever of the locking clamp upwards and
at the same time, press the back shell for-
wards.
Locking clamp for
the back shell
Release lever for
the locking clamp
Figure 48: Locking clamp for the back shell and
release lever
23
Operating instructions TRAVELER 4all Ergo & 4you Ergo
To install the back shell, it is pushed onto the
back tubes and guided into the plug-on mount
on the back joint on both sides. During this
procedure, pull the back shell towards the rear
so that the locking clamp of the back shell
engages on the back cross bar.
Figure 49: Back tubes and back cross bar
Figure 50: Plug-on mount clamp for the back shell
20 Seat system
padding / back shell as it significantly
increases the risk of misadjustment, falling
down or defects.
The seat system generally consists of a belt
system. This can be adjusted subsequently.
Using the fleece hook-and-loop straps, the
slack in the seating surface can be changed so
that it suits your seat cushion system. In doing
so, the seat tension should not have too much
slack to avoid touching the folding mechanism.
Back tubes
Back cross bar
Plug-on mount
clamp for the back
Avoid falling into the seating and back
shell
Advertisement
Table of Contents
