Table of Contents
Advertisement
Operating instructions TRAVELER 4all Ergo & 4you Ergo
29 Storage
When being stored, the product should be kept
in a dry environment and covered up where
possible.
To avoid corrosion and therefore malfunctions
or breakages of components, the product may
not be exposed to any aggressive environ-
mental influences (salt in particular).
30 Transport
When loading or transporting, the product can
be held on the frame and on the back cross
bar.
The transportation of persons in a wheel-
chair or other persons in the product in motor
vehicles when using the specified equipment is
only permitted when observing chapter 28. In
this case, observe the versions in chapter 28.
To reduce the weight, individual compo-
nents, such as the caster wheel forks with
caster wheels and the drive wheels can be
removed for loading and stored separately.
The product and all associated components
must be secured during transport so that they
are not damaged (e.g. by falling over) and do
not become a hazard to persons or other prod-
ucts.
If the product user needs to be trans-
ported over an obstacle, such as a step, and
there are suitable facilities such as a ramp or a
lift available, then these should be used. If
such facilities are not available, then the ob-
stacle is to be overcome by being carried by
two helpers. When carrying the product, it may
not be lifted by the side sections, the drive
wheels or the footrests. We recommend hold-
ing the product on the frame and back cross
bar.
31 Malfunctions
In the event of any malfunctions which cannot
be solved by yourself based on the operating
instructions included in the scope of delivery,
please contact your specialist retailer or PRO
ACTIV directly.
Malfunctions must be solved before any
further use or, if they occur during the journey,
this must be interrupted immediately.
32 Cleaning and care
Regular cleaning of the product is prescribed
to prevent the components becoming clogged
up due to dirt. In particular, the product should
be carefully cleaned after every major use, e.g.
summer or winter holidays.
To avoid corrosion and therefore malfunctions
or breakages of components, the product may
not be exposed to any aggressive environ-
mental influences. If this cannot be avoided,
the product should be cleaned immediately
after such use and moving parts need to be
greased. Regular cleaning prevents corrosion
and increased wear.
In case the product becomes wet when using,
dry it after use.
Clean the quick-release axles of the drive
and caster wheels as well as the ball bearings
and grease these with a little lubricating oil with
high corrosion protection properties (e.g., Ne-
oval MTO 300) approx. every 8 weeks in order
to guarantee the reliable functioning properties.
Clean your product with water, solvent or
neutral cleaning agents. Do not use any abra-
sive cleaning agents or aggressive, acidic
cleaners, to prevent scratching or fading of the
coating or the anodised parts. Use only water
and soap to clean the seat and back padding.
The product must not be cleaned using
steam or high pressure.
54
Advertisement
Table of Contents
