Table of Contents
Advertisement
Bottom M6 fixing screw
with washer (positioning
in the slot)
Figure 109: Bottom M6 fixing screw (AF 5 mm) can
be positioned in the slot
For adjusting the lower leg length, the respec-
tive M6 fixing screw (AF 4 mm at the top, or
5 mm at the bottom) is now loosened on both
sides. The support tubes are then pushed into
the hole grid or along the slots into the correct
position. Take care that the support tubes have
the same length on both sides after the setting.
Once the position has been set, fix the support
tubes by tightening the M6 fixing screws (AF
4 mm at the top, or 5 mm at the bottom) with
washers to 7 Nm on both sides.
With a product frame that has a v shape,
due to the resulting tensioning of the footrest
support tubes in the footrest support plate from
the longitudinal setting, it is necessary to open
the M6 fastening clamp screws (AF 5 mm)
again on the footrest support tubes. View the
procedure in chapter 24.1.
24.5 Divided footrest
Figure 110: Divided footrest, standard position
39
Operating instructions TRAVELER 4all Ergo & 4you Ergo
To fold up one of the two footrest parts, grasp
it and fold it up to the side. Moreover, you can
also turn or pivot the footrest outwards. No
tools are required for folding up and pivoting.
Figure 111: One footrest folded up, option for pivot-
ing outwards marked
There are two M6 fixing screws on each tube
for the length adjustment of the footrest
support tubes or for the adjustment of the
lower leg length. The top M6 fixing screw (AF
4 mm) can be adjusted in a hole grid (gener-
ally, three positions are possible). The bottom
M6 fixing screw (AF 5 mm) can be moved infi-
nitely in a slotted hole. Depending on the ex-
tent of the length adjustment, only one of the
fixing screws or both fixing screws can be
moved in their position.
Top M6 fixing screw with
washer (positioning in
the hole grid)
Figure 112: Top M6 fixing screw (AF 4 mm) can be
positioned in the hole grid
Folding up
Pivot or turn
outwards
Advertisement
Table of Contents
