Table of Contents
Advertisement
There are two M6 fixing screws on each tube
for the length adjustment of the footrest
support tubes or for the adjustment of the
lower leg length. The top M6 fixing screw (AF
4 mm) can be adjusted in a hole grid (gener-
ally, three positions are possible). The bottom
M6 fixing screw (AF 4 mm) can be moved infi-
nitely in a slot. Depending on the extent of the
length adjustment, only one of the fixing
screws or both of them can be moved in their
position.
Top M6 fixing screw
with washer (positioning
in the hole grid)
Figure 101: Top M6 fixing screw can be positioned
in the hole grid
Bottom M6 fixing screw
with washer (positioning
in the slot)
Figure 102: Bottom M6 fixing screw can be posi-
tioned in the slot
To adjust the lower leg length, the respective
M6 fixing screw (AF 4 mm) is now loosened on
both sides. The support tubes are then pushed
into the hole grid or along the slots into the
correct position. Take care that the support
tubes have the same length on both sides after
the setting.
37
Operating instructions TRAVELER 4all Ergo & 4you Ergo
Once the position has been set, fix the support
tubes by tightening the M6 fixing screws (AF
4 mm) with washers to 7 Nm on both sides.
due to the resulting tensioning of the footrest
support tubes in the footrest support plate from
the longitudinal setting, it is necessary to open
the M6 fastening clamp screws (AF 5 mm)
again on the footrest support tubes. View the
procedure in chapter 24.1.
24.4 Footrest folding up to one side
Figure 103: Footrest folding up to one side, stan-
dard position
For footrest folding up to one side, lift the
footplate up in the direction of travel on the left
side.
Figure 104: For folding up to one side, lift the foot-
plate up in the direction of travel on the left side
(product view from the front)
With a product frame that has a v shape,
Footrest
Advertisement
Table of Contents
