Table of Contents
Advertisement
Operating instructions TRAVELER 4all Ergo & 4you Ergo
Long inlet
Short inlet
Figure 16: Long and short inlet with wheel plate
The short inlet has a M6 thread (AF 5 mm) in
the end surface.
Figure 17: Short inlet with thread in the end surface
Because the folding mechanism is fixed to the
wheel plate, the length of the middle section
of the folding mechanism must also be ad-
justed when setting the tipping point.
Folding mechanism middle section
Figure 18: Folding mechanism middle section (view
from below)
Wheel plate
Thread
18.3.2 Adaptation via horizontal position-
ing of the wheel plate
In order to adjust the tipping position, first re-
move the drive wheels via the quick-release
axles (see chapter 22.1) and turn the product
around so that you have direct access to the
wheel plates. Then proceed as follows:
1. This step affects the fixing of the inlets:
The long inlet in the top frame tube is
screwed tight by the screws of the seat
upholstery and therefore does not have to
be fixed.
The short inlet in the bottom frame tube is
not fixed. Therefore, remove the tube plugs
on both sides and turn the long M6 screws
into the thread of the inlet in the frame from
the rear to fix the inlet and to be able to
move it into position afterwards during the
adjustment. These inlets must be moved
into position during the adjustment as they
must be positioned directly behind the
wheel plates.
The tube plugs are inserted very tight
and must be removed using a screwdriver
or a knife.
Figure 19: Short inlet with M6 screw screwed in
(outside the frame for better illustration)
2. Remove the four M6 fixing screws (AF
5 mm) on both wheel plates.
16
Advertisement
Table of Contents
