Height Adjustment Of The Anti-Tipping Support - PRO ACTIV TRAVELER 4all Ergo Operating Instructions Service Booklet

Operating instructions TRAVELER 4all Ergo & 4you Ergo
To install the anti-tippers, the anti-tipping bar
is inserted into the anti-tipping support from
underneath and pulled upwards using the cord.
In doing so, the M6 fixing screw must engage
on the side of the footrest pin and on the other
side, in the recess of the anti-tipping support.
Cord pulled
through upwards
M6 fixing screws
engaged in the
recess of the anti-
tipping support
Figure 121: Anti-tipping bar inserted into the anti-
tipping support
Now the anti-tippers are held at the bottom on
the anti-tipping bar in this position and the
spring retention cap is put onto the anti-tipping
support (loosen the M5 fixing screw on the
spring retention cap first in case this have been
screwed in not to lose it) so that the cord pro-
trudes from the top.
M5 fixing screw
Figure 122: Spring retention cap placed on the anti-
tipping support, cord pulled through upwards and
M5 fixing screw inserted
Cord pulled
through upwards
Finally, the cord is strongly pulled upwards
until the tension spring becomes visible at the
top of the spring retention cap (this must be
held tight in the process). At the same time, the
M5 fixing screw (AF 3 mm) is screwed back
into the spring retention cap and through the
end eyelet of the tension spring. The M5 fixing
screw (AF 3 mm) must be secured using screw
locking fluid.
Figure 123: Tension springs with end eyelets
Figure 124: M5 fixing screw screwed through the
end eyelets of the tension spring
25.3 Height adjustment of the anti-
tipping support
This must be removed first for the height ad-
justment of the anti-tipping support (see chap-
ter 25.2). Then the footrest pin is removed on
which the tension spring is secured using the
M6 fixing screw (AF 4 mm). When loosening
the M6 fixing screw, the footstep bolt must be
retained using a pliers (the footstep pin must
be protected if this is retained using a pliers).
After removing the M6 fixing screw, the tension
spring can be removed.
End eyelet
42