Table of Contents
Advertisement
The angle with slider can be ordered from
PRO ACTIV (order number: 8000 901 000).
If the front edges of the caster wheel bearing
blocks are not standing vertical to the level
ground, the settings must be adjusted. First
adjust the right caster wheel bearing block,
then the left one, and finally check the right
side again. Then proceed as follows:
1. Loosen the M5 stud bolt (AF 2.5 mm).
M5 stud bolt
Figure 92: M5 stud bolt
2. Undo the M6 fixing screws (AF 5 mm)
slightly on the frame inner side.
M6 fixing screw
Figure 93: M6 fixing screws on the frame inner side
3. Now undo the M6 fixing screws (AF 5 mm)
slightly on the frame outer side.
35
Operating instructions TRAVELER 4all Ergo & 4you Ergo
Figure 94: M6 fixing screws on the frame outer side
4. Using the aid of the angle, move the caster
5. Tighten the M6 fixing screws (AF 5 mm)
6. Screw the M5 stub bolt (AF 2.5 mm) back
24 Foot rests
there is sufficient ground clearance under the
footrest. Experience shows that this should not
be less than 4 cm. This must be observed for
the angle adjustment of the footplate and when
setting the lower leg length.
24.1 Angle adjustment of the footplate
The angle of the footplate can be set by un-
doing the M6 fastening clamp screws (AF
5 mm) on the bottom side of the footrest. When
the angle adjustment is completed, tighten the
M6 fastening clamp screws (AF 5 mm) again to
maximum 5 Nm. This tightening torque should
not be exceeded as higher tightening torques
can damage the clamp.
M6 fixing screw
wheel bearing block in a vertical position to
the level ground.
again on the frame outer and inner side to
a tightening torque of 10 Nm and recheck
the vertical setting.
in so that this rests on the M6 fixing screw.
Measures need to be taken to ensure
Advertisement
Table of Contents
