Table of Contents
Advertisement
Rear mouth on the wheelchair axle
Figure 82: Wheelbase extension attached (view
from the inner side of the product)
For removing the wheelbase extension, pull
the actuating cable and keep it in this position.
Release the rear mouth from the wheelchair
axle on both sides by moving the wheelbase
extension down slightly. Then pull the front
mouth from the "Pin torque support" on both
sides. The actuating cable can now be re-
leased.
For changing the drive wheels between the
wheelchair axle and the axle of the wheelbase
extension, see chapter 22.1.
22.6 Other
If tyres, inner tubes or handrims need to be
replaced, please contact your specialist re-
tailer.
23 Caster wheels
23.1 Replacing the caster wheels
For the disassembly a caster wheel, unscrew
the M6 axle fixing screw (AF 4 mm) on one
side.
31
Operating instructions TRAVELER 4all Ergo & 4you Ergo
Figure 83: M6 axle fixing screw on caster wheel axle
Figure 84: Caster wheel with aluminium axle
Now you can see the aluminium axle with a
hexagon socket (AF 4 mm) in the middle of the
axle. This hexagon socket is used to fix the
axle in place, while the second axle fitting
screw (AF 4 mm) is unscrewed. To do this,
insert an Allen key (AF 4 mm) into the hexagon
socket on the aluminium axle and hold it still.
At the same time, unscrew the remaining M6
axle fixing screw (AF 4 mm) on the other side.
Now the caster wheel can be removed from
the fork. One spacer each is mounted to the
right and left on the caster wheel that you are
now able to remove in order for it to be reused
later when reinstalling the new caster wheel. In
case you want to install a different type of
caster wheel, use the enclosed spacers as
these generally differ from one caster wheel to
another.
M6 axle fixing screws
Aluminium axle with
hexagon socket
Advertisement
Table of Contents
