Setting The Brake - PRO ACTIV TRAVELER 4all Ergo Operating Instructions Service Booklet

26.2.2 Setting the brake

Settings on the brake could be necessary for
the following reasons:

You have changed the tyre or the tyre
pressure.

You have changed the wheel track or posi-
tion of the drive wheels.

The brake is pulling unevenly or insuffi-
ciently after extended use.
When adjusting the integral brake, a distinction
must be made between the standard installa-
tion of the integral brake and the installation
with clamping bracket.
To adjust the integral brake lever with stan-
dard installation, proceed as follows on both
sides:
1. Initial situation: Drive wheels mounted on
the product and the integral brakes open.
2. Slightly loosen the M5 clamp screws (AF
4 mm) so that the brake mount can be
moved on the hexagon rail.
Hexagon rail
Figure 139: Hexagon rail and brake mount
M5 clamp screws
Figure 140: M5 clamp screws for positioning the
integral brakes (view from the inner side of the
product)
47
Operating instructions TRAVELER 4all Ergo & 4you Ergo
3. Press the front part of the control element
Figure 141: Brake element resting on the tyre
4. Move the integral brake on the hexagon
Brake
mount
Figure 142: Brake element after correct positioning
of the integral brake
5. Retighten the M5 clamping screws (AF
6. Then check the correct setting of the
to the right or left outwards until the brake
element rests against the tyre. Do not
close the brake completely.
rail so that the brake element is positioned
in such a manner as displayed in the fol-
lowing figure:
approx. 4 mm
4 mm) to 4 Nm.
brakes: In the closed position, the brake
element presses the tyre in by approx.
4 mm.
•