Table of Contents
Advertisement
For attaching the clothing guard, first this is
attached to the back joint shaft with the rear
side section mount and then the front side
section mount is inserted in the "bolted side
section mount".
Figure 57: Rear side section mount attached to the
back joint shaft
21.3 Adjusting the clothing guard posi-
tion
After adjusting the drive wheel position, an
adaptation of the clothing guard position to the
wheel arch is also necessary. The distance
between the tyres and the clothing guard
should be between 5 and 8 mm to avoid pinch-
ing your fingers, scraping the tyres on the
clothing guard, and obstruction when grasping
the handrim.
To adjust the clothing guard position, loosen
the four M5 fixing screws (AF 3 mm) from the
clothing guard mount on each of the clothing
protection guards.
Figure 58: Clothing guard mount
25
Operating instructions TRAVELER 4all Ergo & 4you Ergo
Clothing
guard mount
M5 fixing screws
Slots of the side
section mount
Figure 59: M5 fixing screws and slots in the side
section mounts
Now the front and back side section mounts
can be positioned along the slots in the cloth-
ing protection guard and the side section
mounts. In doing so, ensure that the side sec-
tion mounts can be smoothly inserted back
onto the back jointed shaft and into the side
section mounts.
Then the clothing guard mounts are positioned
accordingly and the M5 fixing screws are
screwed back into the clothing guard mount
with 4 Nm.
Slots of the clothing guard
Figure 60: Slots of the clothing guard
21.4 Adjusting the force required for
removing and installing
To make the removal and installation of the
clothing guard easier or more difficult, adjust-
ments can be made on the "bolted side section
mount". In doing so, there are three options for
adjusting the intensity of the pulling or pressing
force required for removing and installing the
clothing guard.
Advertisement
Table of Contents
