Related Manuals for PRO ACTIV wheel-e
Summary of Contents for PRO ACTIV wheel-e
- Page 1 MOBILITY MADE SIMPLE! Operating instructions wheel-e Operating instructions Service booklet wheel-e Traction device...
-
Page 2: Table Of Contents
Operating instructions wheel-e Contents Preface ............................... 4 Legend ..............................4 CE Declaration of conformity/other information ................. 4 Classification ..........................4 Declaration of conformity ......................4 Manufacturer ..........................4 ... - Page 3 Operating instructions wheel-e 21.1.1 Active and passive positions ..................16 21.1.2 Parking stand height adjustment ................. 17 21.2 Steering column and handlebar ....................18 21.2.1 Seat and handlebar position ..................18 ...
- Page 4 Operating instructions wheel-e Appendix: Medical product passport/record of training ..............33 Appendix: Hand-over certificate ....................... 34 33.1 Required compliance criteria to authorise use ................. 34 33.2 Check list for training the user ....................35 ...
-
Page 5: Preface
If the product is adapted in a manner which traction device, your rehabilitation specialist has not been agreed by PRO ACTIV Reha- dealer or we at PRO ACTIV would be happy to Technik GmbH, this declaration becomes void. deal with any questions you may have about handling it. -
Page 6: Introduction
If contact your rehabilitation specialist dealer or you are of the opinion that damage has PRO ACTIV before using it. occurred during transit, please do the following: When operating the product, the wheelchair operating instructions must also be Record a statement of the facts –... -
Page 7: Intended Use
PRO ACTIV. driving on slopes. The maximum permitted load of the product in For safety reasons, the product may only be... -
Page 8: Technical Specifications
Equipped with a display and a maximum on slopes. speed of 6 km/h: PRO ACTIV delivers the product with a display for the electrical drive system that supports a maximum speed of 6 km/h. This display has no marking on behalf of PRO ACTIV. With this equipment, the product can be used in public areas and on the road. -
Page 9: Maximum Permitted Speed
This strongly depends on the weight distribution between the wheelchair wheels and the product's drive wheel, the total weight PRO ACTIV points out that the use of the of the combination, and the friction coefficient product with this additional display is only of the ground. -
Page 10: Load Weight
When contacting your rehabilitation specialist This value can, however, be reduced due to dealer or PRO ACTIV with regard to your the specifications of the type of wheelchair or product, please always have the serial number its settings. Therefore, you should observe the... -
Page 11: Commissioning
During the initial commissioning of the product, field representative or by a product consultant drive at minimum speed and become from PRO ACTIV. They will fit, if not already accustomed to the driving characteristics of the done, the required fastening elements to your product. -
Page 12: Safety Instructions - While Driving/Using
PRO ACTIV cannot accept any liability or provide any warranty for personal injury and Depending on the optional extras, the material damage caused by such stresses. - Page 13 Operating instructions wheel-e When driving on areas which are used for Do not ride parallel to slopes and pedestrians, observe the maximum permitted inclinations due to the risk of tipping. speed (walking speed 6 km/h) and keep a You may only drive on slopes where the...
-
Page 14: Safety Instructions Regarding Obstacles
Operating instructions wheel-e 15 Safety instructions regarding When driving, never jerk the handlebar to obstacles the left or the right, as this may cause the wheelchair-product combination to tip over sideways in certain circumstances. Driving on steps with the product is forbidden. -
Page 15: Ending The Driving Operation
Operating instructions wheel-e commands, for example, can be prevented. quay walls, landing and berthing locations, Always keep the product in the middle of the paths and locations close to water, ramp. unsecured bridges and dykes. narrow paths, slopes (e.g. ramps and... -
Page 16: Drive Wheel And Tyre Pressure
Operating instructions wheel-e The drive system may only be switched Cap removed on after completing the adaptation process. The product may only be adapted and detached on dry, stable and flat surfaces. 20 Drive wheel and tyre pressure Check the tyre inflation pressure at regular intervals as well as after extreme temperature effects. -
Page 17: Functional Elements
Operating instructions wheel-e Clamp lever Operating lever Valve adapter Figure 10: Valve adapter and clamp lever of the Figure 11: Press down and turn the operating lever compressor Instructions for inserting a new hose: Before inserting a new hose, the rim and... -
Page 18: Parking Stand Height Adjustment
Operating instructions wheel-e 21.1.2 Parking stand height adjustment The height adjustment of the parking stand is Insertion important in order to bring the docking plate of bolt the product into the correct (heigh) position to the adapter. For setting the height of the parking stand, the... -
Page 19: Steering Column And Handlebar
Operating instructions wheel-e 21.2 Steering column and handlebar M6 oval head 21.2.1 Seat and handlebar position screw with washer The seat position and therefore the handlebar position depend on the upper-body stability or the torso musculature. A suitable adjustment of... -
Page 20: Adjustment Of The Handlebar Position
M6 clamp screws on can also often create a customised system or the steering column adapt commercially available systems. mount (height adjustment +/- 25 mm) PRO ACTIV also offers restraint systems such as hip straps with belt (http://www.proactiv-gmbh.com/wheelchair- accessories-safety-lap-belt-lock.html) and velcro fastener (http://www.proactiv- gmbh.com/wheelchair-accessories-safety-lap-... -
Page 21: Handles
If you want to make a change to the handlebar position, please contact your rehabilitation specialist dealer or PRO ACTIV. Please note that after a large adjustment to the handlebar position, the lines and the Brake lever cable lengths must be adjusted. -
Page 22: Drive System
Operating instructions wheel-e 21.4 Drive system Aluminium bracket as a parking brake 21.4.1 Switching on and off To switch the system on, briefly press The rechargeable battery now beeps four times and the system performs a self-check (can be seen by the "countdown" on the speed display). -
Page 23: Recuperation (Rechargeable Battery Re-Charging)
Operating instructions wheel-e When driving in curves, reduce your Support level 2 speed to a minimum and if possible, lean your upper body towards the curve. Support levels 21.4.3 Recuperation (rechargeable battery re-charging) When the product is equipped with a hydraulic... -
Page 24: Rechargeable Battery Pack
Operating instructions wheel-e Clip on the handlebar Figure 32: Clip on the handlebar as a holder for the Figure 35: Pushing the display out of the clip display 21.5 Rechargeable battery pack 21.5.1 General instructions Please refer to the accompanying... -
Page 25: Change Plug Connection As A Switching Solution For Double Rechargeable Battery
Operating instructions wheel-e The contacts of the rechargeable batteries Eccentric lever in must not be short-circuited. A short-circuit the locked position causes very high currents which could damage the rechargeable batteries and/or the product. Slider to position The product's rechargeable batteries may "Rechargeable... -
Page 26: Lights
Operating instructions wheel-e the rail accurately points to "Rechargeable Then switch the drive system back on via the battery 2". display. In order to switch from Rechargeable battery 2 Slider to to Rechargeable battery 1, follow the following position description: "Re-... -
Page 27: Bell
Operating instructions wheel-e Press and hold for 4 sec. Actuation button for the rear lights Figure 43: Switching the LED front lights on and off; Figure 41: Actuation button for the rear lights display lights are activated When the product is equipped with an LED... -
Page 28: Storage
PRO ACTIV. The operating instructions from When the rechargeable batteries are the component manufacturers can also be stored or taken out of use, these may only be downloaded online. -
Page 29: Securing The Product In A Car (Without A Person)
PRO ACTIV directly. When the product is in the transport vehicle, you or the person accompanying you should Malfunctions must be solved before any... -
Page 30: Maintenance
PRO ACTIV. Service and repair work on the or the adapted wheelchair, the tyres must be product may only be carried out by your... -
Page 31: Proof Of Maintenance
Before any re-use, a safety check must be carried out by the manufacturer documented. carried out on the product by PRO ACTIV. In Please bring these operating instructions/ addition to the instructions contained in... -
Page 32: Warranty
30 Liability rechargeable battery housing must be carried As the manufacturer of the product, out. PRO ACTIV is not responsible for its safety if: Before the product can be reused, it must be The product is handled improperly. prepared with care. A disinfection agent that is suitable for medical products must be sprayed ... -
Page 33: Appendix: Tightening Torques And Securing Details
Stability 10.9 M10 x 1 Securing details: All screws on PRO ACTIV products should be secured with thread lock fluid "medium strength" (e.g. Weicon AN302-43), where there are no securing clamps on the screw connections present or there is a lubrication requirement with grease or copper paste. -
Page 34: Appendix: Medical Product Passport/Record Of Training
For minors, or persons who are not responsible for their actions, legal guardians/supervisors/responsible persons are to be trained in the use. This is confirmed by their signature. The data are recorded in the feedback system of PRO ACTIV Reha- Technik GmbH as the manufacturer of the above named product. It is managed in accordance with § 16 BDSG (German Data... -
Page 35: Appendix: Hand-Over Certificate
Operating instructions wheel-e 33 Appendix: Hand-over certificate 33.1 Required compliance criteria to authorise use Completed/ Topics Remarks fulfilled The product is suitable for the customer based on their own judgement and the customer information received regarding the disability-related restrictions. The use intended by the customer is fully consistent with the intended use as described in the operating instructions (see the intended use chapter). -
Page 36: Check List For Training The User
Information on checking the lines and cables has been provided and understood by the user and/or their assistant. The contents of the operating instructions from PRO ACTIV and the other component manufacturers were completely worked through based on the product training and were... -
Page 37: Important Legal Information
Optional equipment with additional display with a maximum speed of 15 km/h or 24 km/h As an option, an additional display with a maximum speed of 15 km/h or 24 km/h can be ordered. PRO ACTIV points out that the use of the product with this additional display is only permitted in certain countries on public roads and otherwise only on private property. -
Page 38: Appendix: Inspection Lists
Operating instructions wheel-e 34 Appendix: Inspection lists Initial inspection: After 200 km or 5 months OK / not OK resolved Kilometre reading:___________________ carried out Check that all screws/fastening elements are firmly seated Functional and safety check of all lights (if fitted), steering... - Page 39 Operating instructions wheel-e Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check that all screws/fastening elements are firmly seated Clean and oil/grease all pivot points and bearings Visual inspection of the frame and attachments for crack formation, deformation, etc.
- Page 40 Operating instructions wheel-e Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check that all screws/fastening elements are firmly seated Clean and oil/grease all pivot points and bearings Visual inspection of the frame and attachments for crack formation, deformation, etc.
- Page 41 Operating instructions wheel-e Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check that all screws/fastening elements are firmly seated Clean and oil/grease all pivot points and bearings Visual inspection of the frame and attachments for crack formation, deformation, etc.
- Page 42 Operating instructions wheel-e Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check that all screws/fastening elements are firmly seated Clean and oil/grease all pivot points and bearings Visual inspection of the frame and attachments for crack formation, deformation, etc.
- Page 43 Operating instructions wheel-e Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check that all screws/fastening elements are firmly seated Clean and oil/grease all pivot points and bearings Visual inspection of the frame and attachments for crack formation, deformation, etc.
- Page 44 Operating instructions wheel-e Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check that all screws/fastening elements are firmly seated Clean and oil/grease all pivot points and bearings Visual inspection of the frame and attachments for crack formation, deformation, etc.
- Page 45 Operating instructions wheel-e Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check that all screws/fastening elements are firmly seated Clean and oil/grease all pivot points and bearings Visual inspection of the frame and attachments for crack formation, deformation, etc.
- Page 46 Operating instructions wheel-e Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check that all screws/fastening elements are firmly seated Clean and oil/grease all pivot points and bearings Visual inspection of the frame and attachments for crack formation, deformation, etc.
- Page 47 Operating instructions wheel-e Subsequent inspection: After another 1,000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check that all screws/fastening elements are firmly seated Clean and oil/grease all pivot points and bearings Visual inspection of the frame and attachments for crack formation, deformation, etc.
- Page 48 Operating instructions wheel-e Your rehabilitation specialist dealer: PRO ACTIV Reha-Technik GmbH Im Hofstätt 11 D-72359 Dotternhausen – Germany Phone +49 7427 9480-0 Fax +49 7427 9480-7025 Email: info@proactiv-gmbh.de www.proactiv-gmbh.com...
Need help?
Do you have a question about the wheel-e and is the answer not in the manual?
Questions and answers