Table of Contents
Advertisement
Operating instructions TRAVELER 4all Ergo & 4you Ergo
Depending on the adjustment of the back-
rest angle, check the tight engagement of the
backrest via the locking pins.
To fold down the backrest, pull on the middle
of the cord towards the front, and at the same
time, fold the backrest downwards until it rests
on the seating area. If you want to return the
backrest back to the desired angle, proceed as
described at the beginning.
19.2 Adjustable back padding & their
adjustment options
The back system "Adjustable back padding"
comprises one belt system and one back up-
holstery. The slack of the backrest can be
adapted to the individual requirements via the
belts with tensioning loops.
First remove the back upholstery that has been
covered over which has been attached using
hook-and-loop straps. The belt system located
underneath has been set in the factory that the
top and the bottom belts have a slack of
approx. 2 cm. The middle belt has been pulled
tight for a good lumbar support.
top belt
middle belt
bottom belt
Figure 30: Belt system of the adaptable back pad-
ding with three belts
To adjust the slack in the belt system, the
tensioning loops of the respective belt are held
on their strap and pressed (strongly) to the
right until the belt slackens.
Tensioning loop with strap
Figure 31: Pull the tensioning loop to the right on its
strap
Figure 32: Tensioning loop open completely
Now the belt can be pulled tight for setting a
small slack or loosened for a large slack (Fig.
33 and 34). The belt does not have to be
threaded out of the tensioning loops for this.
Pull the rear loop part to the left:
Reduce the slack
Figure 33: Reduce the slack
Pull to
the right
20
Advertisement
Table of Contents
