Table of Contents
Advertisement
Figure 43: Central single hand push handle with
: Central single hand push handle with
folding handle end completely folded away
folding handle end completely folded away
The central single hand push handle with
The central single hand push handle with
a foldable handle section may only be used
a foldable handle section may only be used
once the handle end has locked into position in
once the handle end has locked into position in
one of the steps. You can tell it has locked into
You can tell it has locked into
position as the push button springs out and is
position as the push button springs out and is
visible.
21.2 Push handles offset to the back
Push handles offset to the back
Adjusting the height of push handles offset to
Adjusting the height of push handles offset to
the back is possible without tools using the
the back is possible without tools using the
quick release. To adjust the height, the quick
release levers are opened and after completing
release levers are opened and after completing
the adjustment, are closed again. The height
the adjustment, are closed again. The height
can be infinitely adjusted. We recommend
can be infinitely adjusted. We recommend
adjusting both push handles to the same
adjusting both push handles to the same
height.
Figure 44: Closed quick release
To remove the push handles, the M4 end stop
the push handles, the M4 end stop
screws (AF 3 mm) need to be unscrewed and
screws (AF 3 mm) need to be unscrewed and
the quick releases need to be opened.
the quick releases need to be opened.
21
the height, the quick
Operating instructions LITTY 4you
Operating instructions LITTY 4you
M4 End stop screws
M4 End stop screws
Figure 45: End stop screws mounted at the bottom
: End stop screws mounted at the bottom
of the push handles offset to the back
handles offset to the back
After every adjustment or after reattac
After every adjustment or after reattach-
ment following removal, check that the push
ment following removal, check that the push
handles are firmly attached in position. If ne
handles are firmly attached in position. If nec-
essary the tension can be adjusted by turning
essary the tension can be adjusted by turning
the quick release lever clockwise until it
the quick release lever clockwise until it
reaches the end stop. In addition to that, the
s the end stop. In addition to that, the
M4 end stop screws (AF 3 mm) need to have
M4 end stop screws (AF 3 mm) need to have
been mounted again.
22 Storage
When being stored, the wheelchair should be
When being stored, the wheelchair should be
kept in a dry environment and covered up
kept in a dry environment and covered up
where possible.
To avoid corrosion and therefore malfunctio
To avoid corrosion and therefore malfunctions
or breakages of components, the product may
or breakages of components, the product may
not be exposed to any aggressive environ-
not be exposed to any aggressive enviro
mental influences (salt in particular).
mental influences (salt in particular).
23 Transport
Personnel transport of the wheelchair user
Personnel transport of the wheelchair user
or other persons in the product in a motor v
or other persons in the product in a motor ve-
hicle has not been tested by PRO ACTIV and
hicle has not been tested by
is therefore not approved.
pants must only sit on the seats installed in the
pants must only sit on the seats installed in the
vehicle during the journey with the associated
vehicle during the journey with the associated
restraint systems. Failing to observe this leads
restraint systems. Failing to observe this leads
to increased risk of injury for the user as well
to increased risk of injury for the user as well
as for third-parties.
The wheelchair can be fitted with a head-
The wheelchair can be fitted with a hea
rest. These headrest systems are not suitable
rest. These headrest systems are not suitable
for use as headrests when being transported in
for use as headrests when being transported in
a motor vehicle.
All vehicle occu-
Advertisement
Table of Contents
