Brake - PRO ACTIV LITTY 4you Operating Instructions Service Booklet

Operating instructions LITTY 4you Operating instructions LITTY 4you
Before using the wheelchair, after every Before using the wheelchair, after every
load on the anti-tippers and after every adjus tippers and after every adjust-
ment to the product, make sure that the anti ment to the product, make sure that the anti-
tippers are fully functional. In this case the anti functional. In this case the anti-
tipper in operating position must not allow itself tipper in operating position must not allow itself
to be pushed away to the side without undoing to be pushed away to the side without undoing
it from its locked position (cylindrical pin in it from its locked position (cylindrical pin in
groove). In addition to that, the lower edge of groove). In addition to that, the lower edge of
the anti-tippers may be no more than 5 cm
away from the ground. If a larger gap is r away from the ground. If a larger gap is re-
quired or necessary, then you need to work quired or necessary, then you need to work
with your therapists and doctors to practice with your therapists and doctors to practice
and learn to handle the increased risk of ti and learn to handle the increased risk of tip-
ping.
If the functionality of the anti If the functionality of the anti-tippers
should no longer be given or if you are in any e given or if you are in any
doubt about the serviceability, then have it doubt about the serviceability, then have it
checked by your specialist retailer and have it checked by your specialist retailer and have it
repaired before any further use. Otherwise repaired before any further use. Otherwise
there is an increased risk or falling of getting there is an increased risk or falling of getting
injured.
For example, the anti-tippers can tippers can be com-
pletely removed using a quick pin to transport using a quick pin to transport
the product. To do this, press on the locking the product. To do this, press on the locking
knob on the quick pin and pull it out. Afte knob on the quick pin and pull it out. After-
wards, the anti-tippers can be pulled out of the tippers can be pulled out of the
anti-tipper barrels.
Locking knob
Figure 32: Quick Pin with locking knob : Quick Pin with locking knob
The Quick Pins can then be inserted in the The Quick Pins can then be inserted in the
boreholes in the frame tubes to prevent losing boreholes in the frame tubes to prevent losing
them.
re than 5 cm
Figure 33: Anti-tippers removed and quick pins in tippers removed and quick pins in
boreholes in anti-tipper barrels tipper barrels
To attach the anti-tippers tippers again, plug the
anti-tippers into the anti-tipper barrels. Make
sure that you place the cylindrical pins in the sure that you place the cylindrical pins in the
grooves. Then take a quick pin for every anti- grooves. Then take a quick pin for every anti
tipper in your hand, press the locking knob on tipper in your hand, press the locking knob on
the quick pin and insert it back into the bor rt it back into the bore-
hole on the frame tube.

20 Brake

Figure 34: Knee lever brake with brake operation : Knee lever brake with brake operation
integrated in the clothing guard integrated in the clothing guard
tipper barrels. Make
18