Power Over Ethernet - Yealink SIP-T19 E2 User Manual

AC Power
To connect the AC power:
Connect the DC plug on the power adapter to the DC5V port on the phone and connect
1.
the other end of the power adapter into an electrical power outlet.
Connect the included or a standard Ethernet cable between the Internet port on the phone
2.
and the one on the wall or switch/hub device port.
Note
The IP phone should be used with Yealink original power adapter (5V/600mA) only. The use of
the third-party power adapter may cause the damage to the phone.

Power over Ethernet

With the included or a regular Ethernet cable, the SIP-T19P E2 IP phone can be powered from a
PoE-compliant switch or hub.
To connect the PoE for
Connect the Ethernet cable between the Internet port on the phone and an available port
1.
on the in-line power switch/hub.
Note
If in-line power is provided, you don't need to connect the phone to the power adapter. Make
sure the switch/hub is PoE-compliant.
The phone can also share the network with another network device such as a PC (personal
computer). This is an optional connection.
Important! Do not remove power from the phone while it is updating firmware and
configurations.
the SIP-T19P E2 IP phone :
Getting Started
13