Phone Initialization; Phone Status - Yealink SIP-T19 E2 User Manual

User Guide for the SIP-T19(P) E2 IP Phone

Phone Initialization

After your phone is powered on, the system boots up and performs the following steps:
Automatic Phone Initialization
The phone finishes the initialization by loading the saved configuration. The LCD screen displays
"Welcome Initializing...please wait" during this process.
DHCP (Dynamic Host Configuration Protocol)
The phone attempts to contact a DHCP server in your network to obtain valid IPv4 network
settings (e.g., IP address, subnet mask, default gateway address and DNS address) by default.
Note If your network does not use DHCP, proceed to

Phone Status

You can view phone status via phone user interface or web user interface.
Available information of phone status includes:
Network status (IPv4 status or IPv6 status, IP mode and MAC address).

IPv4 uses a 32-bit address.
-
IPv6 is an updated version of the current Internet Protocol to meet the increased
-
demands for unique IP addresses, using a 128-bit address.
Phone status (product name, hardware version, firmware version, product ID, MAC address

and device certificate status).
Account status (register status of SIP accounts).

To view the phone status via phone user interface:
Press
1.
Press
2.
To view the phone status via web user interface:
Open a web browser of your computer.
1.
Enter the IP address in the browser's address bar, and then press the Enter key.
2.
14
, or press Menu->Status.
or to scroll through the list and view the specific information.
Basic Settings
Network on page 15.