Yealink SIP-T19 E2 User Manual page 76

User Guide for the SIP-T19(P) E2 IP Phone
Using the speakerphone

Using the headset

You can also dial the number first, and then choose the way you want to speak to the other
party.
You can also search and dial a contact from call history, local directory or remote phone book.
For more information, refer to
on page 45.
During a call, you can alternate between Speakerphone, Headset and Handset modes by
pressing the Speakerphone key, the Headset key, or by picking up the handset.
The call duration of the active call and far-site's information (name or phone number) are visible
on the LCD screen. In the figure below, the call to "Tom" (the phone number: 1002) has lasted 34
seconds.
To place a call using the handset:
Pick up the handset.
1.
Enter the desired number using the keypad.
2.
Press
3.
The # key is configured as a send key by default. You can also set the * key as the send key, or
set neither. For more information, refer to
You can also dial using the SIP URI or IP address. To obtain the IP address of a phone, press the
Note
key when the phone is idle. The maximum SIP URI or IP address length is 32 characters. For
example, SIP URI: 2210@sip.com, IP: 192.168.1.15.
Your phone may not support direct IP dialing. Contact your system administrator for more
information.
To place a call using the hands-free speakerphone mode:
Do one of the following:
- With the handset on-hook, press
Enter the desired number using the keypad.
Press
With the handset on-hook, enter the desired number using the keypad.
-
Press
66
Contact Management
, , or the Send soft key.
, , or the Send soft key.
, , , or the Send soft key.
on page 31 and
Key As Send on page 25.
to obtain a dial tone.
Call History Management