S200 Base Unit Faults (B-Faults) - Danaher Motion s200 User Manual

8.4.8 S200 Base Unit Faults (b-faults)

As previously stated the base unit Status LED will flash a code if the drive is in a faulted
condition. The following table explains the fault code.
Flash Status
Count
1 No Fault drive disabled
2 Motor Over Temp sensor
has tripped
3 Drive Over/Under Temp
4 Drive I*t Too High;
Exceeded RMS ratings of
the drive.
5 Motor I*I*t Too High;
Exceeded RMS ratings of
the motor.
6 Reserved
7 Bus Over Voltage; Mains
high-line or excessive
regeneration.
8 Bus Under Voltage
9 Motor l-l or l-n Short
10 Output Over Current
11 Hall Fault
12 SFD Configuration Error
13 SFD Short
14 SFD Motor Data Error
15 SFD Sensor Failure
16 SFD UART Error
17 SFD Comm Error
18 Option Card Watch Dog
Time out
19 PosErr Too Large
20
51
Resulting Drive Action
Normal Operation
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Drive Disabled with fault
Reset Method
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power
Clear Fault input, Disable/Enable, Coldstart, GUI
'Drive Reset' Button, or Cycle Power