Danaher Motion s200 User Manual page 2

Record of Revisions
Date Issue
9/28/07 A
10/23/07 B
©2006 2007 Danaher Motion - All rights reserved. Printed in the USA.
NOTICE:
®
Danaher Motion is a registered trademark of the Danaher Corporation. Danaher Motion makes every attempt to
ensure accuracy and reliability of the specifications in this publication. Specifications are subject to change
without notice. Danaher Motion provides this information "AS IS" and disclaims all warranties, express or implied,
including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. It is the
responsibility of the product user to determine the suitability of this product for a specific application.
Safety Symbols
Warnings alert users to potential physical danger or harm. Failure to follow
WARNING warning notices could result in personal injury or death.
Cautions direct attention to general precautions which, if not followed, could
result in personal injury and/or equipment damage.
CAUTION
Notes highlight information critical to your understanding or use of the
product.
NOTE
Safety
READ these instructions before connecting power. Damage can result from
MISWIRING at the power terminals.
WARNING
DANGEROUS voltages are present on power input and motor output terminals.
Only qualified personnel are permitted to transport, assemble, commission, and maintain this equipment. Properly
qualified personnel are persons who are familiar with the transport, assembly, installation, commissioning and
operation of motors, and who have the appropriate qualifications for their jobs.
Read all available documentation before assembling and using. Incorrect handling of products described in this
manual can result in injury and damage to people and/or machinery. Strictly adhere to the technical information
regarding installation requirements.
Keep all covers and cabinet doors shut during operation.
Be aware that during operation, the product has electrically charged components and hot surfaces. Control
and power cables can carry a high voltage, even when the motor is not rotating.
Never disconnect or connect the product while the power source is energized.
After removing the power source from the equipment, wait at least 5 minutes before touching or
disconnecting sections of the equipment that normally carry electrical charges (e.g., capacitors, contacts,
screw connections). To be safe, measure the electrical contact points to each other and to electrical safety
earth with a meter before touching the equipment.
Description
Broke apart Installation and Users – Rewrite
Grammar Issues and minor additions