Table of Contents
Advertisement
7.0 SETUP SOFTWARE
The User Interface software package is called S200 OC TOOLS. Begin by installing the
S200OCTools software. Follow the prompts. Once the software is installed, connect the
computer's RS232 port to the wired and powered drive and motor. Double-click on the
S200OCTools icon to open the software. The software, when opened for the first time, will
automatically invoke a startup wizard that will take the user through a guided setup tour meant to
bring attention to some of the basic setup requirements. The wizard can be defeated by checking
the 'Do not show this wizard again' box. It can be invoked anytime using the 'Utilities / Full Setup
Configuration Utility' menu bar. While there are many options this section of the manual will guide
the reader through some basic setup parameters. After going through this section the software
should be easy to understand and the drive ready to run. The user should be comfortable enough
to proceed without further guidance.
It is important to understand that any change made to the drive is not saved in
non-volatile memory until the NVSAVE function is executed ether through the
NOTE
Utilities Menu or the NV save button
31
Advertisement
Table of Contents
