Table of Contents
Advertisement
6.0 SWITCH SETTINGS
The S200 Position Node has 5 switches that can be adjusted for the user to configure functions.
Each is described in this section. All switches are read at power-up only. Changing of a switch
setting requires power cycling to have the new setting take effect.
Switch Number: S1
S1
Position
0
1
2
3
4
5
6
7
8
9
Switch Number: S2
Switch Number: S11
Switch Number: S12
Switch Number: S13
29
Location: Top of Product
Type: 10-Position Rotary Switch
Function: Set Encoder Equivalent Output Resolution
Encoder Pulse / Revolution
Defined by S200 OC Tools
512 Lines Per Rev
1000 Lines Per Rev
1024 Lines Per Rev
2000 Lines Per Rev
2048 Lines Per Rev
4096 Lines Per Rev
5000 Lines Per Rev
8192 Lines Per Rev
10,000 Lines Per Rev
Location: Top of Product
Switch Type: 4 Position Piano Switch
Function: No function: All switches should be down
Location Front of Product
Switch Type: 10-Position Rotary
Function: Sets the LS part of Modbus, CANopen or DeviceNet
communication address. Used in conjunction with S12 allows address to
be 0-99. Must be '2' for firmware download.
Location Front of Product
Switch Type: 10-Position Rotary
Function: Sets the MS part of Modbus, CANopen or DeviceNet
communication address. Used in conjunction with S11 allows address to
be 0-99. Must be '0' for firmware download.
Location: Top of Product
Switch Type: 4-Postion Rotary
Function: According to table below, CAN bus baud rate.
Advertisement
Table of Contents
