Operating Modes; General - Siemens SINUMERIK 805 Operating Instructions Manual

3 Operating Modes
3.1
General
06.90
3 Operating
Modes
3.1
General
On a machine tool an NC controls:
•
the motion of the tool
•
the motion of the workpiece
by
means of a
set
program
(part program).
Further preparations have
to
be carried
out to
the machine tool before the
actual machining
process can be
started.
For these preparations, the
control
has to
be
set to
certain operating
states to
prepare for
certain operations.
These include:
•
Traversing the tools or the workpiece
to
the
start
position required in the setting up plan
•
Loading the
part
program into the memory of the control
•
Checking and entering the zero offsets
•
Checking and entering the tool offsets
3.1.1 Operating modes
-
overview
The SINUMERIK 805 offers 4 operating modes to bring the control into the desired state.
The following operating modes can be selected directly by operating the relevant key on the
operator
keyboard:
JOG
TEACH IN (available soon)
MDA
AUTOMATIC
Additionally, the following submodes can be selected in JOG mode using the softkeys:
INC (increment)
REPOS (repositioning)
REF (approach reference point)
The SINUMERIK 805 modes and submodes are therefore:
JOG
JOG-INC
JOG-REPOS
JOG-REF
TEACH IN
MDA
AUTOMATIC
®Siemens
AG 1990 All Rights Reserved 6ZB5 410-OEE02
SINUMERIK 805,
SW2 (BA)
3-1