Siemens SINUMERIK 805 Operating Instructions Manual page 148

5 Operating
Sequences
5.3.5 Program
control
06.90
Example:
During
installation of a new
part
program, the override switch also affects the traversing blocks
with programmed rapid
traverse
(GOO) when a function is activated.
DBL decode single block
Program control
When the function
is activated, the part program blocks are processed individually as follows:
flfl
Lzr I
Operate the NC-START key
to
process a decoding single
block.
m
Operating the NC-START key again processes the
next
program block
...etc.
Notes:
•
The SINGLE BLOCK function
operates
similarly.
Operate the SINGLE BLOCK key
to
activate the function.
SINGLE BLOCK SELECTED appears on the screen.
ETl
m
After the NC-START key has been operated, the program
block is processed.
m
Operate the NC-START key again
to
process the
next
program block
...etc.
m
You deselect the function by operating the SINGLE
BLOCK key again.
5-31
®
Siemens AG 1990 All Rights Reserved
6ZB5 410-0EE02
SINUMERIK 805,
SW2 (BA)