Siemens SINUMERIK 805 Operating Instructions Manual page 183

6 Data Interfaces
6.6 Setting data for defining interfaces
06.90
6.6
Setting data for defining interfaces
Interfaces 1
and 2 are defined using setting data.
An alteration of interface parameters for interface
1
or 2 in the
PARAMETER menu
corresponds
to
an alteration in the following setting data areas:
SD area: Interface
SD no. 5010
to 5017 1
SD no. 5018 to 5025
2
1 and 2 SD no. 5026
to
5029
The setting data of both interfaces can be changed by reading in data using the data type
SEA
(see
Section
5.2.12.1).
The alteration only becomes active once the interfaces are started and
is
shown in the PARAMETER menu
in plain text.
The tables below show the allocation of interface
parameters to
setting data
bits as
well
as the
setting data bits for the connection of peripheral devices.
Only those setting data numbers (SD
no.)
which are decisive for the connection of the device
concerned
to
interface 1
or
2
are listed.
Note:
The setting data areas listed above are
not displayed in
a table on the screen, but are
contained in the data read-out
(see
Section 5.2.12.2).
.
1
6-15
®
Siemens AG 1990 All Rights Reserved 6ZB5 410-OEE02
SINUMERIK
805,
SW2 (BA)