Siemens SINUMERIK 805 Operating Instructions Manual page 209

06.90
8 Monitoring
8.3.3 List of alarms
2031
Evaluation factor too high (MD 356*)
At each axis
movement
-
Interlocking of NC START
Setpoint zero
-
Machining stop
Check MD
388*
Scan:
Effect:
Remedy:
2032
Stop during threading
-
Setpoint 0
-
Interlocking of NC START
During thread cutting, the feedrate per revolution was stopped and the
thread
destroyed.
Effect:
Explanation:
2034
Speed reduction area
The software
pre-limit switch was
overshot and the axis decelerated
to
the reduction speed
-
Check
the program
MD 0
-
pre-limit switch
MD
1
-
speed beyond pre-limit switch (reduction speed)
Explanation:
Remedy:
2035
Programmed speed
too
high
The
programmed speed is higher than the contouring speed
based on
the maximum speed of the axes
-
Program lower contouring
speed
Check MD
280* maximum contouring speed
Check MD
296* during reference point approach
Explanation:
Remedy:
©
Siemens AG 1990 All Rights Reserved 6ZB5 410-0EE02
SINUMERIK
805, SW2 (BA)
8-16