Siemens SINUMERIK 805 Operating Instructions Manual page 117

4
Data Area
4.7.2 Service
06.90
The
current contour
deviation (fluctuations in the
following error caused by adjustments to
the speed
controller as a result of changes in load).
Unit: Position control resolution (standard 0.5 pm)
Contour deviation
Example: Displayed value 2
at
a position control
resolution of 0.5 pm corresponds
to
a
contour
deviation of
1
pm.
The following data is
displayed in the
SINUMERIK
805:
The command value
sent
from the control to the
spindle.
The speed command value is displayed in
rev/min).
•
Speed command value
(rev/min)
•
Speed actual value
(rev/min)
The actual speed of the spindle. The speed actual
value is displayed in rev/min).
Spindle position display in DEGREES. The position is
shown in the range 0.1
-
359.9 degrees.
•
Position actual value (degrees)
•
Cutting speed
(m/min) Instantaneous cutting speed of tool
cutting edge in
m/min when
G96 has been selected.
AG 1990 All Rights Reserved
6ZB5 410-0EE02
SINUMERIK
805,
SW2
(BA)
4-49